Ge Wang, Linbi Chen, Haiying Zhou^*, Shanyu Han, Fuming Chen^*

Journal of Renewable Materials, Vol.11, No.3, pp. 1499-1511, 2023, DOI:10.32604/jrm.2022.025130 - 31 October 2022

Abstract To overcome warping in thin bamboo bundle veneer laminated composites (TBLC), their hydrothermal deformation characteristics were systematically investigated in this study. It was found that TBLCs accelerated the release of internal stress in the thickness direction in a hydrothermal environment, which increased their warpage. TBLCs showed increased warpage in the width and diagonal directions upon increasing the temperature. The warpage of Type E increased by 155.88% and 66.67% in the width and diagonal directions, respectively, when the temperature increased from 25 C to 100 C. The symmetrical TBLC with cross-lay-up and odd layers displayed better More >

Claudio Del Menezzi^1,2,3, Antonio Pizzi^2,*, Siham Amirou², Xuedong Xi^4,5

Journal of Renewable Materials, Vol.11, No.2, pp. 539-553, 2023, DOI:10.32604/jrm.2022.024971 - 22 September 2022

Abstract

This article presents the first applied results of using citric acid in combinations with a melamine-urea-formaldehyde (MUF) resin for bonding wood veneers. The chemical reactions involved are shown based on a MALDI ToF analysis of the reaction of the MUF resin with citric acid. The preliminary results of the physical and mechanical properties of the LVL prepared are also presented. Veneers from Populus sp were used to manufacture 5-layer laminated veneer lumber (LVL) of small dimensions. Five combinations of the amount of citric acid, MUF spread rate and pressing parameters were tested. LVL bonded with 20%

More > Graphic Abstract

Qingwei Liu^1,2, Chunmei Yang^1,2,*, Qian Miao^1,2, Yifan Liu^1,2, Jiuqing Liu^1,*, Wenji Yu³

Journal of Renewable Materials, Vol.8, No.12, pp. 1681-1689, 2020, DOI:10.32604/jrm.2020.012031 - 12 November 2020

Abstract Based on the LOM (Laminated Object Manufacturing) process, an inert gas-assisted laser method for wood cutting was proposed. The carbonization degree of wood surface was improved by the introduction of helium (He) gas, and the influence of process parameters on the carbonization layer of wood surface was solved, it was significance to reduce the post-processing of LOM and improve the quality of forming workpiece. The cherry wood veneer was used as the experimental material, under the condition of the same process parameters, the wood was cut with or without inert gas-assisted, and the influence factors… More >

Yan Liu¹, Yanfei Guo¹, Xufeng Sun^1,*, Meng Gong²

Journal of Renewable Materials, Vol.8, No.9, pp. 1111-1127, 2020, DOI:10.32604/jrm.2020.09575 - 03 August 2020

Abstract Poplar Laminated Veneer Lumber (Poplar LVL) is a new type of engineering materials with high strength, good reliability and small variability. Poplar LVL is manufactured from the fast-growing poplar, which is widely used in packaging, furniture and others, however, is rarely adopted in construction. In order to explore the feasibility of poplar LVL trusses in construction of roof, four 4.5-m-span Fink-and-Howe trusses were designed and assembled, which were made of poplar LVL with bolted- and tooth-plated connections. Vertical static loading on the upper chord joints of a truss was imposed by self-balancing test device. The… More >