Rachid Bouregba^1,2, Bel Abbes Bachir Bouiadjra^2,*, Mohamed Mokhtar Bouziane³, Mohamed Amine Bellali², Mokadem Salem²

Journal of Polymer Materials, Vol.41, No.3, pp. 143-158, 2024, DOI:10.32604/jpm.2024.056385 - 30 September 2024

Abstract The use of polypropylene composites in various industrial fields has expanded considerably in recent years. A number of researches have been carried out to characterize the performance of polypropylene and its composites. However, the effects of ageing on the long-term behaviour of this thermoplastic are not well understood. The purpose of this study is to analyse the consequences of thermal degradation on the thermal and mechanical properties of three distinct materials: virgin Polypropylene (PP), virgin Polypropylene + talc (PP/talc), and virgin Polypropylene + Carbon Black (PP/CB) micro-composites. Specimens of these materials underwent exposure in an… More >

Christian Brütting¹, Julia Dreier², Christian Bonten², Volker Altstädt¹, Holger Ruckdäschel^1,*

Journal of Renewable Materials, Vol.9, No.11, pp. 1859-1868, 2021, DOI:10.32604/jrm.2021.016244 - 04 June 2021

Abstract Polylactide (PLA) bead foams show a high potential regarding their applicability in packaging or consumer products. Concerning the comparable properties of PLA to Polystyrene (PS) and the good CO₂ footprint it represents a potential alternative to petroleum-based polymer foams. However, foaming of PLA is challenging, due to its low melt strength, therefore chemical modifiers are often used. Concerning the bead foam technology regarding PLA, the available literature is limited so far. Within this study, the bead foaming behavior of neat and modified amorphous PLA was investigated. The material was modified by talc and an epoxy-based chain More >

Viveca Wallqvist¹, Per M. Claesson², Agne Swerin¹, Patrick A. C. Gane^3,4,3, Joachim Schoelkopf³

FDMP-Fluid Dynamics & Materials Processing, Vol.4, No.2, pp. 85-98, 2008, DOI:10.3970/fdmp.2008.004.085

Abstract It has been shown that talc powder can be compacted into tablets with a preferred orientation of the platelets. The tablets can be obtained with different controlled porosity depending on pressing methods and applied pressure. The tablets can be obtained with or without additives, which may, in turn, be adsorbed. The orientation of the high aspect ratio platy talc, the surface chemistry imparted by the additives and the transported fluid influence the imbibition and permeation rates. Non-polar hexadecane displays a higher imbibition and permeability than water for all particulate orientations during short timescale absorption, likely… More >