Md Zahirul Islam, Chad A. Ulven^*

Journal of Renewable Materials, Vol.10, No.5, pp. 1185-1200, 2022, DOI:10.32604/jrm.2022.018018 - 22 December 2021

Abstract Among natural fibers, flax fiber reinforced polymer matrix composites show excellent dynamic/fatigue properties due to its excellent damping properties. Knowledge about fatigue limit and effect of loading frequency on fatigue limit is very crucial to know before being used a member as a structural component. Fatigue limit of fiber reinforced composite is measured through high cycle fatigue strength (HCFS). The effect of loading frequency on the HCFS of flax fiber reinforced polymer matrix composites was investigated using stabilized specimen surface temperature based thermographic and dissipated energy per cycle-based approaches. Specimens of unidirectional flax fiber reinforced… More >

G. Boopathy^1,2,*, K. Gurusami¹, M. Chinnapandian³, K. R. Vijayakumar⁴

FDMP-Fluid Dynamics & Materials Processing, Vol.18, No.2, pp. 223-232, 2022, DOI:10.32604/fdmp.2022.018225 - 16 December 2021

Abstract In this research study, the mechanical properties of several Polymer matrix composites are investigated. These composites are multi-phase materials in which reinforcing materials are properly mixed with a polymer matrix. More precisely, Nylon 6 reinforced with 5, 15 and 25 wt. % of silicon carbide (SiC) and Nylon 6 reinforced with 5, 15 and 25 wt. % of boron carbide (B₄C), prepared by means of an injection moulding process at three different injection pressures are considered. Specific attention is paid to the tensile and impact strength of these composites. The Taguchi technique is used to optimize the process More >

Nian Li^*

Structural Durability & Health Monitoring, Vol.13, No.4, pp. 331-346, 2019, DOI:10.32604/sdhm.2019.07521

Abstract The investigation focusing on the mechanical behaviors at the microstructural level in composite materials can provide valuable insight into the failure mechanisms at larger scales. A micromechanics damage model which comprises the coupling of the matrix constitutive model and the cohesive zone (CZM) model at fiber-matrix interfaces is presented to evaluate the transverse tensile damage behaviors of unidirectional (UD) fiber-reinforced polymer (FRP) composites. For the polymeric matrix that exhibits highly non-linear mechanical responses, special focus is paid on the formulation of the constitutive model, which characterizes a mixture of elasticity, plasticity as well as damage.… More >

Neeraj Dubey¹, Geeta Agnihotri¹

CMC-Computers, Materials & Continua, Vol.45, No.1, pp. 39-56, 2015, DOI:10.3970/cmc.2015.045.039

Abstract In this paper, midrib of coconut palm leaves (MCL) was investigated for the purpose of development of natural fiber reinforced polymer matrix composites. A new natural fiber composite as MCL/polyester is developed by the hand lay-up method, and the material and mechanical properties of the fiber, matrix and composite materials were evaluated. The effect of fiber content on the tensile, flexural, impact, compressive strength and heat distortion temperature (HDT) was investigated. It was found that the MCL fiber had the maximum tensile strength, tensile modulus flexural strength, flexural modulus and Izod impact strength of 177.5MPa, More >