Huayong Liao^1,2,3,*, Jing Gao^1,2,3, Chunlin Liu^1,2,3, Guoliang Tao^1,2,3

Journal of Polymer Materials, Vol.41, No.1, pp. 45-54, 2024, DOI:10.32604/jpm.2024.053021 - 21 June 2024

Abstract Polymer blending with co-continuous morphology has garnered the interest of many researchers, but corresponding rheological models are rarely presented. In this study, the dynamic rheological behavior of a blend of polypropylene (PP) and low-density polyethylene (LDPE) in the ratio of 50/50 wt% is investigated, and a rheological model suggested by Yu et al. is used to fit the dynamic modulus. The rheological measurement shows that at low frequency, pure PP has higher complex viscosity and dynamic modulus than LDPE. SEM images reveal that the morphology among the 40/60 and 60/40 blends is non-dispersive. The fitting… More >

Attia Irum¹, Abdul Muiz Fayyaz¹, Sara Ayub², Mudassar Raza³, Majed Alhaisoni⁴, Muhammad Attique Khan⁵, Abdullah Alqahtani⁶, Heebum Kim⁷, Byeong-Gwon Kang^7,*

Computer Systems Science and Engineering, Vol.46, No.1, pp. 1265-1276, 2023, DOI:10.32604/csse.2023.032861 - 20 January 2023

Abstract An effective communication application necessitates the cancellation of Impulsive Noise (IN) from Orthogonal Frequency Division Multiplexing (OFDM), which is widely used for wireless applications due to its higher data rate and greater spectral efficiency. The OFDM system is typically corrupted by Impulsive Noise, which is an unwanted short-duration pulse with random amplitude and duration. Impulsive noise is created by humans and has non-Gaussian characteristics, causing problems in communication systems such as high capacity loss and poor error rate performance. Several techniques have been introduced in the literature to solve this type of problem, but they… More >

Huicheng Xu, Hao Xie, Weidong Shan, Weihong Wang^*

Journal of Renewable Materials, Vol.11, No.3, pp. 1123-1135, 2023, DOI:10.32604/jrm.2022.023959 - 31 October 2022

Abstract Straw utilization is a key issue related to agricultural production and air pollution control. In this study, a novel extrusion process was proposed to improve the physical and mechanical properties of the straw-reinforced linear low-density polyethylene (LLDPE) composite. Instead of crushing the straw and mixing it with plastic matrix, the new method mixes straw with plastic matrix in its original form. The intact long rice straws were parallelly spread on the LLDPE film and then rolled up together into a prefabricated roll. The rolls experienced three extrusion processes as follows: (1) twin-screw melting, cooling and… More >

Aman Santoso^1,*, Amirotus Sholikhah¹, Sumari Sumari¹, Muhammad Roy Asrori¹, Anugrah Ricky Wijaya¹, Rini Retnosari^1,2, Ihsan Budi Rachman^1,3

Journal of Renewable Materials, Vol.10, No.11, pp. 2781-2789, 2022, DOI:10.32604/jrm.2022.021401 - 29 June 2022

Abstract Plastic is a basic need for humans, but it has also caused big problems for the environment. Then, the purpose of this study was to determine the effect of the type of plastic and the addition of a zeolite catalyst on the oil yield from the pyrolysis of plastic waste. The research stages were natural zeolite activation, pyrolysis reactor settings, pyrolysis of plastic waste (PP and LDPE types), and characterization. The results showed that the used natural zeolite had a mordenite phase and activated natural zeolite had a higher Si/Al ratio than the inactivated one.… More > Graphic Abstract

Christian Brütting¹, Julia Dreier², Christian Bonten², Volker Altstädt¹, Holger Ruckdäschel^1,*

Journal of Renewable Materials, Vol.9, No.11, pp. 1859-1868, 2021, DOI:10.32604/jrm.2021.016244 - 04 June 2021

Abstract Polylactide (PLA) bead foams show a high potential regarding their applicability in packaging or consumer products. Concerning the comparable properties of PLA to Polystyrene (PS) and the good CO₂ footprint it represents a potential alternative to petroleum-based polymer foams. However, foaming of PLA is challenging, due to its low melt strength, therefore chemical modifiers are often used. Concerning the bead foam technology regarding PLA, the available literature is limited so far. Within this study, the bead foaming behavior of neat and modified amorphous PLA was investigated. The material was modified by talc and an epoxy-based chain More >

Weidong Fang¹, Wuxiong Zhang^1,2, Lianhai Shan^1,*, Biruk Assefa³, Wei Chen⁴

Journal of New Media, Vol.1, No.1, pp. 45-50, 2019, DOI:10.32604/jnm.2019.05786

Abstract As an effective error correction technology, the Low Density Parity Check Code (LDPC) has been researched and applied by many scholars. Meanwhile, LDPC codes have some prominent performances, which involves close to the Shannon limit, achieving a higher bit rate and a fast decoding. However, whether these excellent characteristics are suitable for the resource-constrained Wireless Sensor Network (WSN), it seems to be seldom concerned. In this article, we review the LDPC code’s structure brief.ly, and them classify and summarize the LDPC codes’ construction and decoding algorithms, finally, analyze the applications of LDPC code for WSN. More >