Anastasia Bushueva, Olga Vlasova, Denis Polezhaev^*

FDMP-Fluid Dynamics & Materials Processing, Vol.20, No.4, pp. 847-857, 2024, DOI:10.32604/fdmp.2024.048271 - 28 March 2024

Abstract The steady flow in a Hele-Shaw cell filled with fluids with a high viscosity contrast in the presence of fluid oscillations is experimentally studied. The control of oscillatory dynamics of multiphase systems with interfaces is a challenging technological problem. We consider miscible (water and glycerol) and immiscible (water and high-viscosity silicone oil PMS-1000) fluids under subsonic oscillations perpendicular to the interface. Observations show that the interface shape depends on the amplitude and frequency of oscillations. The interface is undisturbed only in the absence of oscillations. Under small amplitudes, the interface between water and glycerol widens… More >

Victor Kozlov^1,*, Vladimir Saidakov¹, Nikolai Kozlov²

FDMP-Fluid Dynamics & Materials Processing, Vol.20, No.4, pp. 693-703, 2024, DOI:10.32604/fdmp.2024.048068 - 28 March 2024

Abstract The behavior of two immiscible low-viscosity liquids differing in density and viscosity in a vertical flat layer undergoing modulated rotation is experimentally studied. The layer has a circular axisymmetric boundary. In the absence of modulation of the rotation speed, the interphase boundary has the shape of a short axisymmetric cylinder. A new effect has been discovered, under the influence of rotation speed modulation, the interface takes on a new dynamic equilibrium state. A more viscous liquid covers the end boundaries of the layer in the form of thin films, which have the shape of round… More >

J. Srinivas^*, J. V. Ramana Murthy

Frontiers in Heat and Mass Transfer, Vol.6, pp. 1-11, 2015, DOI:10.5098/hmt.6.4

Abstract The paper aims the heat transfer analysis for the flow of two immiscible micropolar fluids inside a horizontal channel, by the first and second laws of thermodynamics under the action of an imposed transverse magnetic field. The plates of the channel are maintained at constant temperatures higher than that of the fluid. The flow region consists of two zones, the flow of the heavier fluid taking place in the lower zone. The condition of hyper-stick is taken on the plates and continuity of velocity, micro-rotation, temperature, heat flux, shear stress and couple stress are imposed More >

S. Homma¹, M. Yokotsuka¹, T. Tanaka¹, K. Moriguchi¹, J. Koga¹, G. Tryggvason²

FDMP-Fluid Dynamics & Materials Processing, Vol.7, No.3, pp. 231-240, 2011, DOI:10.3970/fdmp.2011.007.231

Abstract We develop a three-fluid front-tracking method in order to simulate the motion of an axisymmetry compound droplet, which consists of three immiscible fluids separated by two different interfaces. The two interfaces of the compound droplet are represented by two different sets of the front-tracking elements immersed on the Eulerian grid mesh, where the velocities and the pressure are calculated. The density and viscosity profiles with jumps at the interfaces are successfully determined from the location and the connection information of the front-tracking elements. The motion of a compound droplet is simulated on axisymmetric cylindrical coordinates. More >

S. Chen^1,2, Y. Liu^1,3, B.C. Khoo⁴, X.J. Fan⁵, J.T. Fan⁶

CMES-Computer Modeling in Engineering & Sciences, Vol.19, No.3, pp. 181-196, 2007, DOI:10.3970/cmes.2007.019.181

Abstract The mesoscopic simulation for fluids flow in a square microchannel is investigated using dissipative particle dynamics. The velocity distribution for single fluid in a square channel is compared with the solutions of CFD solver, which is found to be in good agreement with each other. The no-slip boundary condition could be well held for the repulsive coefficient ranged from 9.68 to 18.0. For the same range of repulsive coefficient, various wettabilities could be obtained by changing the repulsive coefficient for binary immiscible fluids, in which the immiscible fluids are achieved by increasing the repulsive force… More >