Binjie Mu¹, Jun Liu^2,*, Yuanfang Chen¹

The International Conference on Computational & Experimental Engineering and Sciences, Vol.29, No.4, pp. 1-2, 2024, DOI:10.32604/icces.2024.011110

Abstract With the improvement of aircraft design requirements, the development of airborne equipment towards lightweight, miniaturization and weight reduction has brought great challenges to the structural design of airborne equipment. Usually, airborne equipment needs to be connected to the fuselage through supporting brackets. In the process of airplane flight, due to the influence of vibration and other complex load conditions, the mounting bracket of airborne equipment is prone to damage caused by the unreasonable structural design of airborne equipment. Some sensitive airborne electronic equipment has special requirements for the dynamic characteristics of the bracket. Therefore, the… More >

Yuhang He, Rongzhuo Zhang, Yifan Zhang, Zheng Wang^*

Journal of Renewable Materials, Vol.11, No.6, pp. 2729-2743, 2023, DOI:10.32604/jrm.2023.025867 - 27 April 2023

Abstract In order to better meet the objective requirements of the use safety of the high-rise glulam building floor structure and the living comfort of the residents, the transient excitation, environmental excitation and frequency spectrum identification methods were used to carry out experimental modal test in-site on the three rooms numbered A, B and C of the same glulam structural building. The three rooms have different functions, different floor sizes and different floor supporting structures. The research results have shown that the first-order bending frequency of the floor structure of Room A is 27.50 Hz, the… More > Graphic Abstract

Teng Yi^1,*, Shuenn-Ren Liou¹, Wen-Yih Kuo^1,2

Journal of Renewable Materials, Vol.10, No.6, pp. 1753-1772, 2022, DOI:10.32604/jrm.2022.018587 - 20 January 2022

Abstract The paper investigates the second-order interactions of parameters in an alkali-activated mixture of paper production waste (PPW) and blast furnace slag (BFS) in Taguchi method. The PPW including lime mud (LM) and paper sludge (PS). This paper provides the experimental models to assess the compressive and flexural strength of them at 7-day and 28-day. The results have shown that the second-order interactions between PPW and alkali-activated activator exists in each experimental model, and the significant interactions affect the selection of optimal compositions. Compared with the interactions between the PPW themselves, the interactions between PPW and… More >

Brian Schwarz, Patrick McHargue, Mark Richardson

Sound & Vibration, Vol.52, No.2, pp. 1-6, 2018, DOI:10.32604/sv.2018.03637

Abstract In this paper, we show how Operating Deflection Shapes (ODS’s) and mode shapes can be obtained experimentally from measurements that are made using only two sensors and two short wires to connect them to a multi-channel acquisition system. This new test procedure is depicted in Figure 1. Not only is the equipment required to do a test much more cost effective, but this method can be used to test any sized test article, especially large ones.
The testing method introduced here involves moving a pair of sensors along together in a prescribed manor, and calculating the Transmissibility between them. More >

Natacha E PILONI, Elizabeth ROBELLO, Julián G BONETTO, Susana PUNTARULO^*

BIOCELL, Vol.40, No.1, pp. 39-42, 2016, DOI:10.32604/biocell.2016.40.039

Abstract Fe is essential for human life because it constitutes the required cofactor for proteins of diverse biological functions. However, the development of oxidative stress by exposure to excessive Fe, share signaling pathways with other treatments including activation of redox-sensitive factors. This study was focused on the comparison on the effects of Fe in the brain and other organs in vivo. The oxidative effects triggered by Fe overload strongly depend not only on the administration protocol, but also on the Fe-compound used, and the studied organ. In both the liver and the brain, Fe content drastically… More >

N.Ishizuka¹, T.Okada², T.Ikeno², K.Shiomi², M.Okuma³

The International Conference on Computational & Experimental Engineering and Sciences, Vol.6, No.2, pp. 145-150, 2008, DOI:10.3970/icces.2008.006.145

Abstract The accurate modeling of structures is very important for any engineering analysis such as simulation and design optimization of mechanical systems for noise and vibration. It is desired that such a modeling process should not be time-consuming and that the created model must have structural dynamic properties corresponding with the actual ones. But in practice, it is often difficult or even impossible to satisfy the desire by using conventional theoretical methods such as the Finite Element Method (FEM) when we consider actual mechanical systems which consist of many substructures. In this paper, under the assumption… More >

Chun Yang^∗,†, Dalin Tang^∗,‡, Shunichi Kobayashi^§, Jie Zheng^¶, Pamela K. Woodard^§, Zhongzhao Teng^*, Richard Bach^||, David N. Ku^∗∗

Molecular & Cellular Biomechanics, Vol.5, No.4, pp. 259-274, 2008, DOI:10.3970/mcb.2008.005.259

Abstract Many acute cardiovascular syndromes such as heart attack and stroke are caused by atherosclerotic plaque ruptures which often happen without warning. MRI-based models with fluid-structure interactions (FSI) have been introduced to perform flow and stress/strain analysis for atherosclerotic plaques and identify possible mechanical and morphological indices for accurate plaque vulnerability assessment. In this paper, cyclic bending was added to 3D FSI coronary plaque models for more accurate mechanical predictions. Curvature variation was prescribed using the data of a human left anterior descending (LAD) coronary artery. Five computational models were constructed based on ex vivo MRI… More >

A. P. S. Selvadurai¹, Q. Yu²

CMES-Computer Modeling in Engineering & Sciences, Vol.9, No.1, pp. 85-110, 2005, DOI:10.3970/cmes.2005.009.085

Abstract A characteristic feature of a polymeric material such as PVC is its hyperelasticity or the ability to experience large strains prior to failure. The exposure of PVC to chemicals such as acetone and ethanol results in embrittlement or the loss of the hyperelasticity property. In this paper, we examine the mechanical behaviour of a PVC membrane that has been exposed to ethanol. Due to leaching of the plasticizer, the constitutive response of the PVC changes from a hyperelastic material to a hardened material that displays dominant yield behaviour and particularly one that is capable of… More >