Alan F.N. Boss¹, Manuella G.C. Munhoz¹, Gisele Amaral-Labat², Rodrigo G.A. Lima², Leonardo I. Medeiros^2,3, Nila C.F.L. Medeiros^2,3, Beatriz C.S. Fonseca², Flavia L. Braghiroli^4,*, Guilherme F.B. Lenz e Silva¹

Journal of Renewable Materials, Vol.12, No.10, pp. 1639-1659, 2024, DOI:10.32604/jrm.2024.056004 - 23 October 2024

Abstract Radar Absorbing Materials (RAM) are a class of composites that can attenuate incident electromagnetic waves to avoid radar detection. Most carbon allotropes that have the potential to be used as RAM are either carbon nanotubes (CNTs), graphene, carbon black (CB) and ultimately, sustainable porous carbon (SPC). Here, black wattle bark waste (following tannin extraction) was used as a sustainable source to produce SPC made from biomass waste. It was characterized and used as a filler for a silicone rubber matrix to produce a flexible RAM. The electromagnetic performance of this composite was compared with composites… More >

Wei Shi^1,2, Zhengyi Li¹, Xiaobing Xu¹, Yingshui Yu¹, Xiaofei Ding¹, Heng Ju^1,*

FDMP-Fluid Dynamics & Materials Processing, Vol.20, No.1, pp. 97-108, 2024, DOI:10.32604/fdmp.2023.029028 - 08 November 2023

Abstract Two-dimensional carbon/carbon (2D C/C) composites are a special class of carbon/carbon composites, generally obtained by combining resin-impregnated carbon fiber clothes, which are then cured and carbonized. This study deals with the preparation of a protective coating for these materials. This coating, based on graphite, was prepared by the slurry method. The effect of graphite and phenolic resin powders with different weight ratios was examined. The results have shown that the coating slurry can fill the pores and cracks of the composite surface, thereby densifying the surface layer of the material. With the increase of the… More >

Melanie Patrick^a, Messiha Saad^a,*

Frontiers in Heat and Mass Transfer, Vol.3, No.4, pp. 1-8, 2012, DOI:10.5098/hmt.v3.4.3007

Abstract Thermal characterization is essential to the proper assignment of composites to specific applications. Specific heat, thermal diffusivity, and thermal conductivity are critical in the engineering design process and in the analysis of aerospace vehicles, space systems, power generation, transportation systems, and energy storage devices including fuel cells. This paper examines the thermal properties through the thickness of Carbon-Carbon and the impact of Graphitization is explored. Following ASTM standards, the Flash Method and Differential Scanning Calorimetry measured thermal diffusivity and specific heat respectively. These measurements and density data allowed for the computation of thermal conductivity. More >