Amnart Boonloi^a, Withada Jedsadaratanachai^b,*

Frontiers in Heat and Mass Transfer, Vol.13, pp. 1-11, 2019, DOI:10.5098/hmt.13.28

Abstract This paper presents the numerical investigations (finite volume method with SIMPLE algorithm) on flow structure, heat transfer behavior and performance assessment in heat exchanger square channel placed with 30o inclined square ring (ISR). The influences of ring size and placement on flow and heat transfer characteristics are considered for laminar flow region with the Reynolds number in the range around 100 – 2000. The purpose for the insertion of the ISR in the square channel is to induce the vortex flow and also increase the turbulent mixing. The numerical result reveals that the ring size More >

G. C. Sankad^* , Asha Patil

Frontiers in Heat and Mass Transfer, Vol.10, pp. 1-8, 2018, DOI:10.5098/hmt.10.17

Abstract Heat transfer effect on the flow of Herschel Bulkley fluid moving in a non-uniform channel is analyzed. The peristaltic wall is considered to be coated with a porous lining. The pertinent parameter effects are studied graphically for the analytical solutions of temperature profile, rate of temperature, heat transfer coefficient and mechanical efficiency. The temperature profile, heat transfer coefficient and the rate of temperature decrease with increase in the Darcy number. Thickening of the porous wall coating raises the temperature profile and the rate measure of temperature. Mechanical efficiency is more in a convergent channel than More >

P. R. Sharma^a , Sushila Choudhary^a,* , O. D. Makinde^b

Frontiers in Heat and Mass Transfer, Vol.9, pp. 1-7, 2017, DOI:10.5098/hmt.9.18

Abstract Steady two dimensional laminar magnetohydrodynamic (MHD) slip flow and heat transfer of a viscous incompressible and electrically conducting fluid past over a flat exponentially non-conducting stretching porous sheet embedded in a porous medium with non uniform permeability in the presence of non uniform heat source is investigated. The governing equations of velocity and temperature distributions are solved numerically and the effects of different physical parameters are shown through graphs. The rate of shear stress and the rate of heat transfer at the sheet are derived, discussed numerically and their numerical values for various values of More >

Meryem NAOUM¹, Mustapha EL ALAMI²

FDMP-Fluid Dynamics & Materials Processing, Vol.12, No.2, pp. 56-68, 2016, DOI:10.3970/fdmp.2016.012.056

Abstract A numerical study of mixed convection from a U-shaped channel is carried out. The flow is considered two dimensionnel. The inlet opening is adjusted in the right vertical part of the channel, while the outlet one is placed on the left vertical part. Navier–Stokes equations are solved using a control volume method and the SIMPLEC algorithm is considered for the treatment of pressure–velocity coupling. Special emphasis is given to detail the effect of the Reynolds and Rayleigh numbers on the heat transfer generated by mixed convection. The results are given for the parameters of control More >

Srikrishna Sahu¹, K. Muralidhar¹, P.K. Panigrahi¹

FDMP-Fluid Dynamics & Materials Processing, Vol.3, No.3, pp. 265-286, 2007, DOI:10.3970/fdmp.2007.003.265

Abstract Convection in a differentially heated cavity partly filled with silicone oil has been experimentally studied. The air-oil layers are subjected to a temperature difference in the vertical direction, with the lower wall being heated with respect to the top. The overall geometry is that of an enclosed cavity that is octagonal in plan. Heights of oil layers considered for experiments correspond to 30, 50, and 70% of the vertical cavity dimension. Measurements have been carried out using a shadowgraph technique. A limited number of interferograms have also been recorded. The shadowgraph technique has been validated… More >