Yueqiang Yu^1,3, Minzheng Jiang^1,*, Sheng Gao^1,*, Ting Jiang¹, Bakary S. Doumbia², Bo Yan¹, Tingang Ma¹, Kexin Ren¹, Yinsong Liu¹

Journal of Renewable Materials, Vol.11, No.9, pp. 3583-3593, 2023, DOI:10.32604/jrm.2023.030725 - 20 July 2023

Abstract High-quality wood products and valuable wood crafts receive everyone’s favor with the rapid development of the economy. In order to improve the cutting surface quality of wood forming parts, the cutting experiment of renewable Fraxinus mandshurica was conducted by waterjet-assisted CO₂ laser (WACL) technology. A quadratic mathematical model for describing the relationship between surface roughness changes and cutting parameters was established. The effects of cutting speed, flow pressure and laser power on the kerf surface roughness of Fraxinus mandshurica when cutting transversally were discussed by response surface method. The experimental results showed that kerf surface roughness decreased… More >

Fatemeh Rezaei^1,2,*, Milan Gaff^1,3,4,*, Róbert Nemeth⁵, Jerzy Smardzewski⁶, Peter Niemz⁷, Haitao Li^8,9, Anil Kumar Sethy^1,10, Luigi Todaro¹¹, Gourav Kamboj¹, Sumanta Das¹, Roberto Corleto¹, Gianluca Ditommaso¹, Miklós Bak⁵

Journal of Renewable Materials, Vol.11, No.8, pp. 3277-3296, 2023, DOI:10.32604/jrm.2023.028352 - 26 June 2023

Abstract The performance of engineered wood products is highly associated with proper bonding and an efficient cutting method. This paper investigates the influence of CO₂ laser cutting on the wetting properties, the modified chemical component of the laser-cut surface, and the strength and adhesive penetration near the bondline. Beechwood is cut by the laser with varying processing parameters, cutting speeds, gas pressures, and focal point positions. The laser-cut samples were divided into two groups, sanded and non-sanded samples. Polyvinyl acetate adhesive (PVAc) was used to bond the groups of laser-cut samples. After assembly with cold pressing, the… More >

Ting Jiang^1,3, Chunmei Yang^1,2,*, Yueqiang Yu³, Bakary S. Doumbia^1,2, Jiuqing Liu^1,*, Yan Ma^1,2

Journal of Renewable Materials, Vol.9, No.1, pp. 119-128, 2021, DOI:10.32604/jrm.2021.011490 - 30 November 2020

Abstract

As a natural and environmentally friendly renewable material, Northeast China ash wood (NCAW) (Fraxinus mandshurica Rupr.) was cut by water-jet assisted CO₂ laser (WACL), the surface quality was evaluated by surface roughness of cut section. The surface roughness was measured by three-dimensional (3D) profilometry. Furthermore, the micromorphology of machined surface was observed by scanning electronic microscopy (SEM). Carbon content changes of machined surface were measured by energy dispersive spectrometer (EDS). A relationship between surface roughness and cutting parameters was established using response surface methodology (RSM). It is concluded that the cutting speed, laser power and water pressure

More >