Zerong Tang, Tiecheng Song^*, Jing Hu

CMC-Computers, Materials & Continua, Vol.81, No.1, pp. 1835-1854, 2024, DOI:10.32604/cmc.2024.056983 - 15 October 2024

Abstract The Internet of Vehicles (IoV) will carry a large amount of security and privacy-related data, which makes the secure communication between the IoV terminals increasingly critical. This paper studies the joint beamforming for physical-layer security transmission in the coexistence of Vehicle-to-Infrastructure (V2I) and Vehicle-to-Vehicle (V2V) communication with Reconfigurable Intelligent Surface (RIS) assistance, taking into account hardware impairments. A communication model for physical-layer security transmission is established when the eavesdropping user is present and the base station antenna has hardware impairments assisted by RIS. Based on this model, we propose to maximize the V2I physical-layer security… More >

Shimaa M. Amer¹, Ashraf A. M. Khalaf², Amr H. Hussein^3,4, Salman A. Alqahtani⁵, Mostafa H. Dahshan⁶, Hossam M. Kassem^3,4,*

CMES-Computer Modeling in Engineering & Sciences, Vol.138, No.3, pp. 2749-2767, 2024, DOI:10.32604/cmes.2023.029138 - 15 December 2023

Abstract Side lobe level reduction (SLL) of antenna arrays significantly enhances the signal-to-interference ratio and improves the quality of service (QOS) in recent and future wireless communication systems starting from 5G up to 7G. Furthermore, it improves the array gain and directivity, increasing the detection range and angular resolution of radar systems. This study proposes two highly efficient SLL reduction techniques. These techniques are based on the hybridization between either the single convolution or the double convolution algorithms and the genetic algorithm (GA) to develop the Conv/GA and DConv/GA, respectively. The convolution process determines the element’s… More >

Baofeng Ji^1,2,3,4,*, Yifan Liu^1,2,3,4, Tingpeng Li¹, Ling Xing², Weixing Wang², Shahid Mumtaz⁵, Xiaolong Shang⁶, Wanying Liu², Congzheng Han⁴

CMES-Computer Modeling in Engineering & Sciences, Vol.138, No.1, pp. 679-689, 2024, DOI:10.32604/cmes.2023.028667 - 22 September 2023

Abstract With the development of information technology, more and more devices are connected to the Internet through wireless communication to complete data interconnection. Due to the broadcast characteristics of wireless channels, wireless networks have suffered more and more malicious attacks. Physical layer security has received extensive attention from industry and academia. MIMO is considered to be one of the most important technologies related to physical layer security. Through beamforming technology, messages can be transmitted to legitimate users in an offset direction that is as orthogonal as possible to the interference channel to ensure the reception SINR… More >

Syed Asghar Ali Shah¹, Tariqullah Jan¹, Syed Muslim Shah², Ruhul Amin Khalil^1,*, Ahmad Sawalmeh³, Muhammad Anan⁴

CMC-Computers, Materials & Continua, Vol.76, No.1, pp. 1065-1084, 2023, DOI:10.32604/cmc.2023.039826 - 08 June 2023

Abstract Fractional order algorithms have shown promising results in various signal processing applications due to their ability to improve performance without significantly increasing complexity. The goal of this work is to investigate the use of fractional order algorithm in the field of adaptive beamforming, with a focus on improving performance while keeping complexity lower. The effectiveness of the algorithm will be studied and evaluated in this context. In this paper, a fractional order least mean square (FLMS) algorithm is proposed for adaptive beamforming in wireless applications for effective utilization of resources. This algorithm aims to improve… More >

Samer Alabed^*, Mohammad Al-Rabayah, Wael Hosny Fouad Aly

CMC-Computers, Materials & Continua, Vol.73, No.3, pp. 5641-5653, 2022, DOI:10.32604/cmc.2022.030371 - 28 July 2022

Abstract Rotman lens, which is a radio frequency beam-former that consists of multiple input and multiple output beam ports, can be used in industrial, scientific, and medical applications as a beam steering device. The input ports collect the signals to be propagated through the lens cavity toward the output ports before being transmitted by the antenna arrays to the destination in order to enhance the error performance by optimizing the overall signal to noise ratio (SNR). In this article, a low-cost Rotman lens antenna is designed and deployed to enhance the overall performance of the conventional… More >

Qiuqin Yang¹, Linfang Li¹, Ming-Xing Luo^1,*, Xiaojun Wang²

CMC-Computers, Materials & Continua, Vol.73, No.1, pp. 1863-1877, 2022, DOI:10.32604/cmc.2022.027120 - 18 May 2022

Abstract In real communication systems, secure and low-energy transmit scheme is very important. So far, most of schemes focus on secure transmit in special scenarios. In this paper, our goal is to propose a secure protocol in wireless networks involved various factors including artificial noise (AN), the imperfect receiver and imperfect channel state information (CSI) of eavesdropper, weight of beamforming (BF) vector, cooperative jammers (CJ), multiple receivers, and multiple eavesdroppers, and the analysis shows that the protocol can reduce the transmission power, and at the same time the safe reachability rate is greater than our pre-defined… More >

Subaselvi Sundarraj^*, Gunaseelan Konganathan

Intelligent Automation & Soft Computing, Vol.34, No.2, pp. 1197-1213, 2022, DOI:10.32604/iasc.2022.025026 - 03 May 2022

Abstract Software Defined Wireless Sensor Networks (SDWSN) provides a centralized scheduling algorithm to decrease energy consumption compared to WSN. The sensor nodes have a finite battery capacity in the SDWSN that reduces the lifetime of the nodes. To harvest energy for energy depleted nodes without interfering with the eventful data transfer in the clustered SDWSN, an energy efficient mobile harvesting scheme with the Multiple Input Single Output (MISO) beamforming technique is proposed. The mobile harvesting scheme transfer the energy to the energy starving node and the beamforming algorithm which transmits the energy in the desired direction… More >

Omar A. Saraereh^*, Ashraf Ali

CMC-Computers, Materials & Continua, Vol.70, No.3, pp. 5383-5397, 2022, DOI:10.32604/cmc.2022.021724 - 11 October 2021

Abstract With the rapid growth in the number of mobile devices and user connectivity, the demand for higher system capacity and improved quality-of-service is required. As the demand for high-speed wireless communication grows, numerous modulation techniques in the frequency, temporal, and spatial domains, such as orthogonal frequency division multiplexing (OFDM), time division multiple access (TDMA), space division multiple access (SDMA), and multiple-input multiple-output (MIMO), are being developed. Along with those approaches, electromagnetic waves’ orbital angular momentum (OAM) is attracting attention because it has the potential to boost the wireless communication capacity. Antenna electromagnetic radiation can be… More >

Ke Song^1,*, Paul Liu², Dongquan Liu³

CMES-Computer Modeling in Engineering & Sciences, Vol.128, No.3, pp. 1133-1150, 2021, DOI:10.32604/cmes.2021.016008 - 11 August 2021

Abstract A novel beamforming algorithm named Delay Multiply and Sum (DMAS), which excels at enhancing the resolution and contrast of ultrasonic image, has recently been proposed. However, there are nested loops in this algorithm, so the calculation complexity is higher compared to the Delay and Sum (DAS) beamformer which is widely used in industry. Thus, we proposed a simple vector-based method to lower its complexity. The key point is to transform the nested loops into several vector operations, which can be efficiently implemented on many parallel platforms, such as Graphics Processing Units (GPUs), and multi-core Central… More >

Samer Alabed¹, Ibrahim Mahariq^1,*, Mohammad Salman¹, Mustafa Kuzuoglu²

CMC-Computers, Materials & Continua, Vol.69, No.1, pp. 575-588, 2021, DOI:10.32604/cmc.2021.018245 - 04 June 2021

Abstract In this article, a low-cost electromagnetic structure emulating photonic nanojets is utilized to improve the efficiency of wireless relay networks. The spectral element method, due to its high accuracy, is used to verify the efficiency of the proposed structure by solving the associate field distribution. The application of optimal single-relay selection method shows that full diversity gain with low complexity can be achieved. In this paper, the proposed technique using smart relays combines the aforementioned two methods to attain the benefits of both methods by achieving the highest coding and diversity gain and enhances the More >