M. O. Petinrin^a , B. A. Sikirullahi^a, T. T. Olugasa^a, O. M. Oyewola^a,b,*

Frontiers in Heat and Mass Transfer, Vol.19, pp. 1-8, 2022, DOI:10.5098/hmt.19.28

Abstract Tubes are commonly employed in heat exchangers for their ease of production and capacity to sustain high pressure. In this study, the heat and flow transfer behaviour of cam-shaped tube bank in staggered configuration at varying angles of attack 0°to 180° was numerically investigated. The study was carried out by solving the continuity, momentum, energy and realizable k-ε transport equations using the finite volume-based ANSYS Fluent solver. This was performed to acquire the friction factor and heat transfer characteristics in the air inlet velocity range of 9 to 15 m/s. The results showed that the… More >

Ida Bagus Alit, I Gede Bawa Susana^* , I Made Mara

Frontiers in Heat and Mass Transfer, Vol.19, pp. 1-7, 2022, DOI:10.5098/hmt.19.25

Abstract The study compared solar dryers with hot air from a heat exchanger double furnace during the drying of white turmeric. Solar drying is the process of drying the product in the sun. The hot air dryer consists of two furnaces with heat exchanger pipes and a drying chamber with six vertical shelves. During the test, the use of rice husk energy in a constant amount of 35 kg. Temperature and drying rate are higher in hot air dryers. Tests carried out for 420 minutes resulted in a change in moisture content from 88% to 35.88%… More >

Wakana Hiratsuka^a , Takashi Fukue^b,*, Hidemi Shirakawa^c, Katsuyuki Nakayama^d, Yasushi Koito^e

Frontiers in Heat and Mass Transfer, Vol.15, pp. 1-8, 2020, DOI:10.5098/hmt.15.16

Abstract This paper describes a possibility of heat transfer enhancement in a mm-scale flow channel by using a combination of some projections and pulsating flow. The objective of this research is to develop a novel heat exchanger for miniaturized productions such as high-density packaging electronic equipment by applying pulsating flow to enhance heat transfer while inhibiting an increase of pressure drop. In order to evaluate the possibility of applying pulsating flow to miniature water channels, a three-dimensional flow and heat transfer analysis was performed. Heat transfer performance of a combination of pulsating water flow and a More >

Teng Huang^a,* , Xuefang Li ^a,† , Lin Cheng^b,‡

Frontiers in Heat and Mass Transfer, Vol.15, pp. 1-8, 2020, DOI:10.5098/hmt.15.15

Abstract As a non-flammable, non-toxic refrigerant, supercritical CO₂ (ScCO₂) has been increasingly used for heat transfer applications. In this study, the ScCO₂ flow and heat transfer in a set of full-size three-dimensional serpentine tubes were modeled with different inner diameters and tube pitches. The standard k-epsilon model was used for the turbulence modeling. The results show the effect of the different tube inner diameters and tube pitches on the flow and heat transfer of ScCO₂ for a given flow flux or inlet Reynolds number. The heat transfer coefficient decreases as both the tube pitch and the inner diameter… More >