Boonchai Lertnuwat

Frontiers in Heat and Mass Transfer, Vol.18, pp. 1-9, 2022, DOI:10.5098/hmt.18.1

Abstract The aim of this work is to numerically investigate the effect of mounting winglet vortex generators on different positions in rectangular-duct-type air heaters. The two investigated positions were the absorber plate and the insulation plate, opposite to the absorber plate. Four shapes of winglet vortex generator, i.e. perforated rectangular winglet vortex generators (P-RWVG), rectangular winglet vortex generators (RWVG), perforated trapezoidal winglet vortex generators (P-TWVG) and trapezoidal winglet vortex generators (TWVG), were used. Results showed that heat-transfer capability would be better if the winglet vortex generators were mounted on the opposite insulation plate in the cases More >

Foued Chabane^a,b,*,†, Noureddine Moummi^a,b, Abdelhafid Brima^a,b, Said Benramache^c

Frontiers in Heat and Mass Transfer, Vol.4, No.1, pp. 1-6, 2013, DOI:10.5098/hmt.v4.1.3006

Abstract This paper presents an experimental thermal efficiency analysis for a novel flat plate solar air heater with several mass flow rates. The aims are to review of designed and analyzed a thermal efficiency of flat-plate solar air heaters. The measured parameters were the inlet and outlet temperatures, the absorbing plate temperatures, the ambient temperature, and the solar radiation. Further, the measurements were performed at different values of mass flow rate of air in flow channel duct. After the analysis of the results, the optimal value of efficiency is higher level of mass flow rate equal… More >