Open Access

ARTICLE

Investigation of the Film Formation in Dynamic Air Spray Painting

Deqing Han, Yong Zeng^*, Jintong Gu, Bin Yan

School of Mechanical Engineering, Yancheng Institute of Technology, Yancheng, 224051, China

* Corresponding Author: Yong Zeng. Email:

Fluid Dynamics & Materials Processing 2024, 20(10), 2393-2415. https://doi.org/10.32604/fdmp.2024.053114

Received 24 April 2024; Accepted 02 July 2024; Issue published 23 September 2024

Abstract

To accurately predict the film thickness distribution during dynamic spraying performed with air guns and support accordingly the development of intelligent spray painting, the spray problem was analyzed numerically. In particular, the Eulerian-Eulerian approach was employed to calculate the paint atomization and film deposition process. Different spray heights, spray angles, spray gun movement speeds, spray trajectory curvature radii, and air pressure values were considered. Numerical simulation results indicate that the angle of spray painting significantly affects the velocity of droplets near the spray surface. With an increase in the spraying angle, spraying height and spray gun movement speed, the maximum film thickness decreases to varying degrees, and the uniformity of the film thickness also continuously worsens. When the spray gun moves along an arc trajectory, at smaller arc radii, the film thickness on the inside of the arc is slightly greater than that on the outside, but the impact on the maximum film thickness is minimal. Increasing air pressure expands the coating coverage area, results in finer atomization of paint droplets, and leads to a thinner and a more uniform paint film. However, if the pressure is too high, it can cause paint splattering. Using the orthogonal experimental method, multiple sets of simulation calculations were conducted, and the combined effects of spraying height, spray angle, and spray gun movement speed on the film thickness distribution were comprehensively analyzed to determine optimal configurations. Finally, the reliability of the numerical simulations was validated through dynamic spray painting experiments.

---

Keywords

---