Table of Content

Open Access


Introduction to the Special Issue on Design and Simulation in Additive Manufacturing

Di Wang1, Yongqiang Yang1,*, Yingjun Wang1,*, Li Yang2, Hao Wang3, Shoufeng Yang4
1 School of Mechanical & Automotive Engineering, South China University of Technology, Guangzhou, 510641, China
2 Department of Industrial Engineering, University of Louisville, Louisville, Kentucky, 40292, USA
3 Department of Mechanical Engineering, National University of Singapore, 117575, Singapore
4 Materials Research Group, Faculty of Engineering and the Environment, University of Southampton, Southampton, SO17 1BJ, UK
* Corresponding Authors: Yongqiang Yang. Email: ; Yingjun Wang. Email:
(This article belongs to this Special Issue: Design & simulation in Additive Manufacturing)

Computer Modeling in Engineering & Sciences 2021, 126(1), 1-4.

Received 28 November 2020; Accepted 03 December 2020; Issue published 22 December 2020


This article has no abstract.

Cite This Article

Wang, D., Yang, Y., Wang, Y., Yang, L., Wang, H. et al. (2021). Introduction to the Special Issue on Design and Simulation in Additive Manufacturing. CMES-Computer Modeling in Engineering & Sciences, 126(1), 1–4.

This work is licensed under a Creative Commons Attribution 4.0 International License , which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
  • 2339


  • 1639


  • 0


Share Link

WeChat scan